To Next Page

To Previous Page

R&S OSP Preparing for Use

Operating Manual 1505.3896.12 - 14 28

Switch on the R&S OSP120 with Monitor and Keyboard connected (not applicable to

the OSP130)

At the end of the booting process, the IP address will be displayed as shown below for

the OSP120 and the OSP130. The values of the IP address shown are only examples.

Press Okay button or the ENTER key on the keyboard (OK key for the R&S OSP130)

for confirmation and to continue the operation.

Manual TCP/IP configuration

If your network does not support DHCP, proceed as follows:

1. Connect the R&S OSP120 or OSP130 via a cross-over RJ-45 cable to your

computer (or network not supporting DHCP).

2. Set the network configuration of your computer to work with a static IP address.

The following setup is recommended:

3. Switch on the R&S OSP and wait until boot-up is finished.

The R&S OSP now can be accessed under its default IP address from your computer.

Questions and Answers:

Need help?

Do you have a question about the R&S OSP and is the answer not in the manual?

R&S OSP Specifications

General