To Next Page

To Previous Page

R&S OSP Getting Started

Operating Manual 1505.3896.12 - 14 71

3.6.3 Import of Path Configuration

Once you have generated the path configuration in virtual mode without instruments,

you can import it on an R&S OSP120 or R&S OSP130 with the same configuration as

used in virtual mode.

3.7 GUI Info Line

With OSP Panel version 2.57 onwards, you can activate an info line which is shown at

the R&S OSP130 built-in display, connected monitor and Web-GUI. (For details on

your firmware version, see the related Release Notes.)

Configure the info line either via the OSP Panel application or via SCPI

“SYSTem:OPTion” commands (see chapter 7.4.6). You can only configure the info line

with the instrument connected, i.e. with OSP Panel in physical mode or via SCPI

command.

Questions and Answers:

Need help?

Do you have a question about the R&S OSP and is the answer not in the manual?

R&S OSP Specifications

General