To Next Page

To Previous Page

R&S OSP Getting Started

Operating Manual 1505.3896.12 - 14 70

If any extension unit R&S OSP150 is used, select OSP Frame F02 and configure the

module slots as requested. For any additional R&S OSP150, proceed accordingly.

After completing the configuration, press and .

Then the OSP Panel shows the requested module configuration, only, as shown in the

following example menu.

3.6.2 Path Configuration

You can now configure the path as usual (see chapter 3.4), with the exception that a

path can only be exported. Exporting is shown in the example below:

Questions and Answers:

Need help?

Do you have a question about the R&S OSP and is the answer not in the manual?

R&S OSP Specifications

General