6 | Electrical connection
80.06.243_iVarioProL-iVarioProXL_IM_en-US 45 / 64
The connectors are in the electrical compartment next to the toroidal trans-
former. The power supply is set to 3AC440V as standard.
1. Close the electrical compartment.
2. Connect the unit to mains power.
3. Switch the unit on.
4. Run a performance check. Verify that the measured performance data
matches the setting.
>> The power supply has been successfully switched.
6.10 Device options
Base with height-adjustable feet
If the device is equipped with height-adjustable feet, the connected loads do not
change.
To Next Page
Loading...
