8 | Water connection
48 / 64 80.06.243_iVarioProL-iVarioProXL_IM_en-US
8.2 Connecting the water inlet
The water connection is located on the rear side of the device.
a The water hose fulfills the hygiene requirements for drinking water hoses
in your country.
a Safety devices, such as check valves or CA system separators are installed
in the feed line on the tap.
a Line for shared cold water connection: 3/4 Inch
a Water hardness: at least 4°dH
1. Connect the supplied water hose to the water inlet for the device.
2. Open the tap.
>> The water inlet is connected.
To Next Page
Loading...
