Machine settings
65
8
Example of full border spreading during normal fertilising:
Figure 8.4: Full border spreading during normal fertilising
Full border spreading in normal fertilisation mode refers to a spreading process
in which a bit more fertiliser lands beyond the border of the field. Therefore, there
is a slight underfertilisation at the field boundary.
The following settings are to be applied to the machine according to the fertiliser
chart:
Specified parameters:
Type of fertiliser: ENTEC 26 COMPO BASF
Working width: 12 m
Spreading disc type: M1
Forward speed: 10 km/h
Application rate: 300 kg/ha
NOTICE
On the full border spreading side, both spreading vanes must be set to the
value stated in the fertiliser chart.
On the other spreading disc, the spreading vanes remain in their normal
fertilisation position.
Mounting height: 50/50 (A = 50 cm, B = 50 cm)
Metering slide adjustment: 160
PTO speed: 540 rpm
spreading vane adjustment
Full border spreading side:
Other spreading disc
(normal fertilisation position):
A3-A3
C3-B2
To Next Page
Loading...
