Machine settings
71
8
1. Determine the position of the spreading vane in the fertiliser chart or by
carrying out a test using the practice test kit (optional equipment).
2. Use the adjustment lever to adjust the spreading vanes and to change the
spreading discs.
3. Remove the adjustment lever [1] from the bracket.
6. Adjust the angle and length of the spreading vane.
7. Push the locking bolt upwards with the adjustment lever until it clicks into
place.
n WARNING
Danger of injury due to sharp edges
The spreading vanes have sharp edges.
Your hands are at risk when you change or adjust the spreading
vanes.
Wear protective gloves.
[1] Adjustment lever position
(hopper, left side according to
direction of travel)
Figure 8.10: Adjustment lever
4. Insert the adjustment lever
into the locking bolt opening
[3] under the spreading disc.
5. Press downwards.
The locking bolt [2] is un-
latched.
Figure 8.11: spreading vane adjustment
To Next Page
Loading...
