INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 33 of 60
14.7.2 Static-1
The STATIC 1 function is a procedure that offsets wheel
vibrations using a single weight with clip on a single
plane positioned exactly at 12 o’ clock.
Enter the measurements (see Par. 14.2.1 or 14.6.1) and
proceed as described in Par. 14.5 "Dynamic balancing"
(only for wheel inner side).
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
14.7.3 Static-2
The STATIC 2 function is a procedure that offsets wheel
vibrations using a single adhesive weight on a single
plane positioned exactly at 12 o’ clock.
Enter the measurements (see Par. 14.2.1 or 14.6.1) and
proceed as described in Par. 14.5 "Dynamic balancing"
(only for wheel inner side).
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
14.7.4 Dynamic
The DYNAMIC program allows the wheels balancing
by fitting two clip adhesive weights: one on the outside
and one on the inside rim. Enter the measurements
(see Par. 14.2.1 or 14.6.1) and proceed as described
in Par. 14.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
The procedure has now been completed.
14.7.5 ALU-S
The ALU-S program permits balancing wheels by two
fitting adhesive weights on the outer and inner sides
of the rim. Enter the measurements (see Par. 14.2.1 or
14.6.1) and proceed as described in Par. 14.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
1297-M007-1_R
G3.140R - GP3.140R - G3.140RS - GP3.140RS
RAVAGLIOLI S.p.A.
To Next Page
Loading...
Need help?
General
