CHAPTER
13
016-4010-001 Rev. J 111
CHAPTER 13
CERTIFICATION AND
COMPLIANCE
ROADWAY HOMOLOGATION
The Accept Roadway Homologation Terms page will be displayed during the initial calibration of the RS1 system in
either of the following conditions:
• Operating with a generic tune-set
• Operating on the European continent
Carefully review the on-screen disclaimer before proceeding.
FIGURE 1. Roadway Homologation
When roadway homologation is accepted (check box enabled), the following parameters will be applied to RS1
operation:
• An operator presence method will be required while operating with the RS1 auto-steering system enabled.
• Auto-steering cannot be enabled above 16.1 km/h [10 mph].
• Auto-steering will disengage above 19.3 km/h [12 mph].
NOTE: To engage and operate with autosteering higher than the limits above, review the disclaimer on the
page and do not accept the homologation terms.
To Next Page
Loading...
Need help?
General
