34
Steering Position Sensor (SPS) Cable Connection and Routing
The SPS is only installed on Wheel, Articulated and QUADTRAC tractors. Track tractors do not require
a SPS to be installed, but must ensure that the supplied blanking plug is used on the SPS cable
section of the Smartrax Loom to prevent any contaminants being introduced into the Smartrax Loom.
STEPS
1) The SPS cable is to connect from the SPS
setup on the tractor to the Smartrax Loom (as
shown in Figure on page 34).
NOTE: The location of the SPS setup is
tractor specific.
NOTE: For tractors that don’t require the SPS to be installed, ensure that the supplied
blanking plug is used to blank off the port on the SPS cable section of the Smartrax
Loom. This is done to prevent any contamination from being introduced into the Smartrax
Loom.
KEY POINTS
NOTE: Ensure SPS cable is mounted
neatly. Secure it (where possible) to exist-
ing points on the tractor using cable ties.
Ensure it is not routed near heated areas
such as the exhaust. Do not route it in close
proximity to moving parts.
To Next Page
Loading...
Need help?
General
