EasyManua.ls Logo

ray FACE - Usage Safety Precautions; Power Connection Safety

ray FACE
91 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RAYFace 1. Introduction
9
Install it 10cm away from the end of the table.
Leaving a BATTERY in an extremely high temperature surrounding environment
can result in an EXPLOSION or the leakage of flammable liquid or gas.
A BATTERY subjected to extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas.
Risk of fire or explosion if the battery is replaced by an incorrect type. Dispose of
used Batteries according to the instructions.
Use appropriate for the Storage environment and Operation environment conditions of
the product.
Precautions for Use
Risk of malfuction, equipment failure, or bodily injury
Do not place heavy objects on top of the product.
Do not disconnect the power cord during operation.
If used in a manner not specified by the manufacturer, the protection function may be
impaired.
The recommended illuminance level for the subject location is 500 ~ 1,500 Lux.
Do not look into the beam. This product is classified as Risk Group 2 (RG2) of IEC
62471-5.
Precautions for Power Connection
Risk of electric shock or fire
Do not use loose power outlets or damaged power cord.
Do not touch the power cord with wet hands.
Grasp the power cord and pull to disconnect, and avoid pulling out of the cable line.
Remove the power cord during a thunderstorm.

Related product manuals