ray FACE - Appendix B. Messages

RAYFace Appendix B. Messages
82
Appendix B. Messages
Message
Cause
Guide
Currently installed
cameras contain
unsupported firmware.
A camera that is not
supplied by the
manufacturer is installed.
Contact your sales representative to
replace the camera.
The camera is not
recognized.
The USB cable
connected to the camera
is disconnected.
Open the back cover and confirm that
related cables are connected properly.
If the problem persists, contact your
sales representative.
The camera is
connected via USB
2.0.
The USB cable
connected to the camera
is not securely
connected.
Open the Back cover and confirm that
related cables are connected properly.
If the problem persists, contact your
sales representative.
A problem occurred
while configure camera
options.
There is a problem with
the camera while
preparing to capture.
Restart the device.
If the problem persists even after restart,
contact your sales representative.
There is a problem with
the camera while
powering on.
There is a problem with
the camera while
preparing to capture.
Restart the device.
If the problem persists even after restart,
contact your sales representative.
There is a problem with
the camera
connection.
There is a problem with
the camera while
preparing to capture.
Restart the device.
If the problem persists even after restart,
contact your sales representative.
Unable to initialize the
camaras.
There is a problem with
the camera while
preparing to capture.
Restart the device.
If the problem persists even after restart,
contact your sales representative.
Unable to reconstruct
the captured data in 3D
model.
Captured without a
subject.
Verify the subject has been captured
properly.