Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-C3000XZ~RFL-C12000XZ
③ The communication sends “EEC”, or the host computer software clicks the button；
④ The communication sends “ELE”, or the host computer software clicks the button；
⑤ XP1-A1 is high level, XP1-A6 is low level or floating;
⑥ XP1-A1 is high level, XP1-A3 is high level;
⑦ XP1-A1 is high level, XP1-A8~A14 are low level or floating;
⑧ XP1-A1 is high level, XP1-A6 is high level
⑨ XP1-A1 is high level, XP1-A3 is low level or floating
⑩ XP1-A1 is high level, not all XP1-A8~A14 are low level;
⑪ Communication send “EMON” or the host computer software click the
“ON” button to emitting the laser;
The communication sends "EMOFF" or the host computer software clicks the
“OFF” button to turn off the laser;
⑫ The communication sends “ABN” or the host computer software clicks the button to
output guide laser；
Communication send “ABF” or the host computer software click the button to turn
off the guide laser；
⑬ Communication sends “SDC XX” to set the power percentage, XX represents the power percentage,
or the host computer software clicks the button；
5.1 ON Mode
In“ON” mode, users can set different operating modes by using the Raycus Laser Control System
(RLCS) or using a direct communication command method, which can be memorized by the laser source
even after powering off.
To Next Page
Loading...
