Raycus RFL-C3000S-CE User Manual

24
18
Emission
Enable
LAS-C
Digital Input
5-24Vd
C
<10
mA
120ms
Positive edge activates
emission in REM mode
19
READY
READY
Digital output
24VdC
＞
10mA
120ms
High=Laser is ready
20
System
Common
GND2
Return
---
---
---
Return for pin
17/18/19/21/22/23/24
21
Error RESET
RESET
Digital Input
5-24Vd
C
<10
mA
120ms
Rising edge reset (the
resettable alarm)
22
Laser Alarm
S-ERR
Digital output
24VdC
＞
10mA
120ms
High=Alarm status
23
Power started
POWER
Digital output
24VdC
＞
10mA
120ms
High= The main power
supply is started
24
Laser emission
LASER
Digital output
24VdC
>10mA
100ms
High=Laser is emission
 Caution: Please check the control voltage level and ensure that the level is in
accordance with the requirements. Over voltage and voltage ripple may damage
the product.
The Service Security Interface is pin 1-4 and pin2-3， of CTRL-INTERFACE.If the pin 2-3
and pin 1-4 are disconnected, the laser will immediately stop emitting light, and the laser Ready
signal output will change to low level. Be sure to short-circuit pin 2-3 and pin 1-4 before using
the laser. If it is not short-circuited, the laser will display InterLock alarm after power-on.
 Interlock interface must not be connected to active signal, otherwise it
will cause interface damage and laser alarm.
4.4.2 TCP/IP Interface Configuration
Thedefault IP address of this product is 192.168.0.10, only supporting UDP communication.
The laser listens for connection on port is 8098, and the command must be sent in a single data
string.
Table 8 Thepin definitions of Ethernet interface
PIN
FUNCTION
DESCRIPTION
1
TX+
TRANSMIT+
2
TX-
TRANSMIT-

Raycus RFL-C3000S-CE Specifications

General

Brand	Raycus
Model	RFL-C3000S-CE
Category	Measuring Instruments
Language	English