?
More information....
See the 'Using the Fishfinder' chapter of the Reference Manual.
How do I change the range or shift the image?
D6736_2
How do I zoom in on an area of the screen?
How do I change the operating frequency?
Your system automatically adjusts the display depth range, selecting the shallowest depth that
keeps the bottom on the lower half of the window. You can however, set this manually if required
and move the image within the selected page up or down. Using the range controls will affect all
fishfinder windows.:
IN - decrease depth.
OUT - increase depth.
Press RANGE
(IN or OUT)
Turn to alter
shift value.
RANGE
IN
OUT
RANGE
IN
OUT
Press
RANGE
AUTO MAN
Press
RANGE SHIFT
XX FT
Press
OK
ZOOM...
Press Select zoom level
ZOOM FACTOR
x2 x3 x4 xR
ZOOM
ON SPLIT OFF
FISHFINDER
SETTINGS...
Press
Select MAN
FREQUENCY
AUTO MAN
Select required
frequency
To see more detail of the bottom structure, target images etc, zoom in and enlarge a portion of the
image.
FISHFINDER
SETTINGS...
Press
Press
GAIN ...
Select MAN
GAIN MODE
AUTO MAN
How do I change the gain mode?
SELECT FREQ
200 50 BOTH
AUTO GAIN
LO MED HIGH
Select required
gain level
What's under the boat?
Using the fishfinder....
Card No. 14
TRANSDUCER
SETTINGS
ZOOM BOTTOM LOCK A - SCOPE PRESENTATION
200 kHz - maximum
definition in shallow water.
50 kHz - maximum depth
penetration in deep water
Both - 200 kHz & 50 kHz
displayed simultaneously.
Auto mode - automatically selects 50 kHz or 200 kHz. This is the default mode.
Auto mode - automatically adjusts control to display sharpest image. This is the default mode.
Manual (MAN) - Single or dual
Low - when cruising
Med - when trolling
High - when fishing
Manual (MAN)
On - zooms image only.
Split - zooms image and
standard fishfinder image
simultaneously.
Zoom
To Next Page
Loading...
Need help?
General
