Chapter 3: Adjusting SmartPilot Settings 37
difficul t than the other groups. After pressing
auto
, the disp lay will show
CAL ?
. When yo u see this, press the
1
and
+1
k eys together to enter D ealer
Calibration.
4. When you ha ve entered one of the Calibratio n groupings, press
disp
key to
scroll d own through the items with in that groupin g:
Note:
You can go backwards thr ough the lis t by press ing and hold ing the disp key for one
second.
5. When you reach an item you wish to adjust, use the
1, +1, 10
and
+10
keys
(as appro priate) to change the valu e.
6. If you then w ant to adjust settings in an other Calibra tion group , press
standby
and then repeat steps 2 to 5 as necessary.
7. When you ha ve made all the changes y ou want to mak e, p ress and hold
standby
for two second s to exit Calibration mode and save chang es.
3.2 Display Calibr ation
Disp lay Calibratio n allows you to select the type of bar graph and heading shown
on the SmartPilot display , and set the information to be shown on the data pages.
D9332-1
or
or
To adjust values
2 seconds
(save changes)
Data pages
Press disp
for next page
Accessing Display
Calibration
Display Calibration
81282_1.book Page 37 Monday, October 2, 2006 1:58 PM
To Next Page
Loading...
Need help?
General
