Raymarine ST3000 - 4.3 Drive unit installation

42 ST3000 Wheel Drive Autopilot - Owner’s Handbook
4 Installing the Wheel Pilot
Mounting the socket
To mount the SeaTalk socket:
1. Fix the template (supplied at the end of the handbook) onto the
bulkhead at the selected socket location
2. Carefully drill the 18 mm (
23
/
32
in) clearance hole and 2.4 mm
(
3
/
32
in) pilot holes, then remove the template.
3. Fit the plug cap to the socket body.
4. Locate the O-ring seal into the groove between the plug cap and
socket body.
5. Cut and strip back the power cables and SeaTalk cables (if fitted).
6. Thread both cables through the bulkhead hole and connect to the
relevant pins on the socket.
7. Attach the socket to the bulkhead using the two self tapping
screws supplied.
8. Secure the cables to the bulkhead.
D5634-1
Screen
(Sea Talk 0 V)
Red
(+12 V)
Yellow
(Sea Talk
Data)
Black
(Supply 0 V)
Pin
Identification
Stripes
To SeaTalk
To power supply
81194_1.book Page 42 Wednesday, July 25, 2001 12:10 PM