Raymarine ST3000 - Nmea Cabling

Chapter 4: Installing the Wheel Pilot 41
4 Installing the Wheel Pilot
Connecting ST3000 control unit to ST60 instruments
Connecting ST3000 control unit to ST50 instruments
NMEA cabling
To connect NMEA equipment, you will need to use a
SeaTalk/NMEA interface (part number: E85001) to convert the
NMEA information into SeaTalk data. You can then connect the
SeaTalk/NMEA interface to the SeaTalk socket.
SeaTalk
instruments
D5656-1
5A fuse/
breaker
12A fuse/
breaker
Yellow
(data)
Screen
(ground)
SeaTalk socket
D5632-1
5 A fuse/
breaker
12 A fuse/
breaker
Yellow
(data)
Screen
(ground)
SeaTalk socket
81194_1.book Page 41 Wednesday, July 25, 2001 12:10 PM