50 ST3000 Wheel Drive Autopilot - Owner’s Handbook
4 Installing the Wheel Pilot
5. When you have determined the correct position for the pedestal
bracket, carefully draw around its base and inside its the
elongated fixing holes.
6. Tighten the clevis mounting bolts.
7. Drill four 4.3 mm (
11
/
64
in) pilot holes for the pedestal bracket
fixing screws at the lower end of each elongated hole position.
This allows the belt to be subsequently tightened if necessary.
D5644-1
81194_1.book Page 50 Wednesday, July 25, 2001 12:10 PM
To Next Page
Loading...
