Allows you to quickly get your results on paper by using the built-in thermal printer.
5: Display with Touch Panel
The instrument can be easily manipulated and fully controlled by the touch screen panel. If
preferred, an external mouse or keyboard can be connected to the USB Port to control the system.
6: Safe Indicator
Green Light on: System is in safe mode. Ready for handling test leads, connections.
Red Light on: Unsafe mode! Don’t remove any cables and don't touch the test object.
7: Measurement Input B
Connect the redblue measurement cable to this input.
8: Measurement Input A
Connect the bluered measurement cable to this input.
9: HV GND
This is also a measurement Input. Connect the green-yellow cable to this input.
10: Guard (V)
Everything connected to this potential is not taken into account for the measurement. It is the same
potential as the shield of the measurement cables.
11: HV Output
1
This is the receptacle for the high voltage. Connect the orange high voltage cable to this input.
12: Safety receptacle
Here you can connect the Safety-Switch.
For more detail about this receptacle have a look in the chapter 11.1.3 Safety on page 94.
1 This is not the same plug as the one from the CAPO 2.5, the cables are not interchangeable
To Next Page
Loading...