REMOTE CONTROL (CONTINUED)
BATTERY INSTALLATION
Slide the battery compart-
ment cover in the direction
of the arrow.
install two "AAA" batteries,
paying attention to the
polarity diagram in the
battery compartment.
Replace the compartment
cover.
BATTERY PRECAUTIONS
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh
ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury
from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow
battery manufacturer's directions.)
EFFECTIVE DISTANCE OF THE REMOTE CONTROL
_I FEET
NOTES: • When there is an obstacle between the TVNCR and the remote control, the remote control may not
operate,
• When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the
Remote sensor of the TVNCR, the remote operation may be unstable.
10
To Next Page
Loading...
Need help?
General
