SPECIAL PLAYBACK
TO VISUALLY SEARCH FOR DESIRED POINTS
When either the RFWD or REW button is pressed in the PLAYBACK mode, the speed search picture will appear.
When pressed twice, the search picture will increase speed. Speed search time depends upon the speed used
during recording. See chart below.
To rewind or fast forward a tape, press the STOP button, and then press the REW or RFWD button.
To visually search backward, press the REW button
once or twice in the PLAYBACK mode.
Press the PLAY button to resume normal viewing
• speed.
SPEED SEARCH TIMES \\
\
ONCE TWICE
To visually search forward, press the RFWD button
once or twice in the PLAYBACK mode.
EFWD
Press the PLAY button to resume normal viewing
speed.
SP (Standard Play) 3 X 5 X
LP (Long Play) 7 X 9 X
SLP (Super Long 9 X 15 X
• Play) •
\
\
\
\
\
SKIP SEARCH
\
\
\
\
TO WATCH STILL PICTURE
Press the SKIP SEARCH button in the PLAY mode. The VCR will
search forward through approximately 30 seconds of the tape (e.g.
unwanted commercial time) for each press of the SKIP SEARCH
button (maximum six presses) and then resume normal playback.
For example : 1 press: 30 seconds of tape
2 press: 60 seconds of tape
3 press: 90 seconds of tape
SKIP
SEARCH
%
P- •
Press the PAUSE/STILL button in the
PLAYBACK mode.
PAUSE/STILL
%
Press the PLAY button or PAUSE/
STILL button to resume normal
_layback,
NOTES: • Best results during speed search and still playback can be obtained with video cassettes recorded in the
"SLP" mode.
• The audio output is muted during Speed Search and Still.
• A few noise bars will appear on the TV screen during Speed Search and Still.
8 • To prevent damage to the tape, Still and Speed Search mode is automatically changed to the Playback
mode after 5 minutes.
To Next Page
Loading...
Need help?
General
