SLEEP
To set the TV/VCR to turn off after a preset amount of time, press the SLEEP button on the remote control.
The clock will count down 10 minutes for each press of the SLEEP button (120, 110, ...10, 0). After the sleep
time is programmed, the display will appear briefly every ten minutes to remind you that the sleep timer is
operating. To confirm the sleep timer setting, press the SLEEP button and the remaining time will be momen-
tarily displayed. To cancel the sleep timer, press the SLEEP button repeatedly until the display turns to 0.
SLEEP
SLEEP1
120
TV/CAPTIO N/TEXT
Press this button to switch between normal TV and
the two closed caption modes (captions and full
screen text). Closed captioning will display text on the
screen for hearing impaired viewers.
TV/CAP/
TEXT
%
CAPTIONCH1 I
QUICK VIEW
rThis button allows you to go back to the last channel "_
selected by pressing the QUICK VIEW button. Press
this button again to return to the last channel you
were watching.
QUICKVIEW
CH0_2 I
NOTES: • If using an indoor antenna or if TV reception is very poor, the Closed Caption Decoder text may not appear.
In this case, adjust the antenna for better reception or use an outdoor antenna.
• When activating the Closed Captioned Decoder, there will be a short delay before the Closed Captioned
text appears on the screen.
• Closed Captioned TV programs can be recorded and played back on a VCR with the Closed Captioned text
intact. The Closed Captioning text will disappear during Cue, Rewind and Pause modes or if the VCR
tracking is not adjusted properly.
X J
• Closed Captioned text is only displayed in locations where it is available. "J 1
h |
To Next Page
Loading...
Need help?
General
