Safety instructions and regulations
1
BAL_SYS20_RED_EN_2V2_REC_102-020110693 7/ 27
CAUTION
Unexpected OPENING / CLOSING / ROTATION
• Bruises and contusions from the door wings/apron
No persons or objects are allowed in the opening area of the door.
No safety devices (sensors) should be removed or disabled.
Do not rush through a door that is already closing.
DANGER
Electric shock
• Electric shock, burns, death.
Disconnect the drive from the power supply during cleaning, maintenance
and replacement of parts.
Danger zones
Security- and surveillance equipment
The passages of the plant are monitored by sensors. It is important that they work faultlessly and are
under no circumstances set out of service.
Danger warnings on the product
If necessary, the country specific regulations have to be adhered to.
Reconstructions and changes to the product
Unauthorized modifications to the installation will release the manufacturer from all liability for any re-
sulting damage.
State of technology
This system was developed using state of the art technology and officially recognized technical safety
regulations. The system, depending on its options and diameter, comply with the requirements of the
Machine Guidelines 2006/42/EG as well as EN 16005 and DIN 18650 (D).
Nevertheless, danger may arise if not used as intended.
IMPORTANT
Installation, commissioning, inspection, maintenance and repair work may only
be conducted by qualified, trained and authorized technicians.
After commissioning or repair work, fill in the check list and give it to the custom-
er for safe keeping.
We recommend obtaining a service agreement.
1.3
1.3.1
1.3.2
1.3.3
1.4
To Next Page
Loading...
