Recommended and planned spare- and wear parts
10
BAL_SYS20_RED_EN_2V2_REC_102-020110693 27/ 27
Recommended and planned spare- and wear parts
Spare part/Wear part Interval
* CO48 (Silicon or Rubber) 1 year
* Pulley CO48 3 years
Battery 3 years
Antistatic brush 3 years
Door leaf guide (plastic) 3 years
Guiding pad 3 years
Safety blocking ball (TOS Break-out system) 5 years
Pulley If wear is detected
Gear belt If wear is detected
Roller, wheel If wear is detected
Counter wheel If wear is detected
Track If wear is detected
Carriage + Track + Rubber damping profile If wear is detected
Belt clamp If wear is detected
Hinge (plastic)
for cladding height 200 mm
If wear is detected
Locking device (VRR) If wear is detected
Motor If wear is detected
Leaf central seal If wear is detected
Lateral sealing profile If wear is detected
Floor guide rail If wear is detected
Light barrier If wear is detected
Control Breakdown/Failure
BDE Control unit Breakdown/Failure
BBGV Green break glass housing Breakdown/Failure
Others Breakdown/Failure
* Mechanical power storage device for escape routes in France.
NOTICE
Depending on the version of the door installed, not all the listed spare and wear
parts are installed.
10
To Next Page
