red lion IMP User Manual

PROGRAMMING MODULE #3 - PROGRAM FUNCTIONS ACCESSIBLE W/ FRONT PANEL LOCKOUT
This programming module programs what is accessible through the front
panel when the PGM. DIS. pin is connected to common (COMM.).
Note: The term “Quick Programming” is used to refer to the ability to change the
information that can be accessed from the front panel when the “PGM. DIS.”
terminal is connected to “COMM.”.
DISPLAY ALARM VALUES
If the alarm option is installed, this selects whether the alarm values will or
will not be displayed.
“dSP AL” < > “yES” or “NO”
ENTER ALARM VALUES =
If “YES” was selected for display alarm values, this will select if alarm values
may be modified from the front panel. If “NO” was selected for display alarm
values, then this step will default to “NO” and will not be displayed for selection.
“ENt AL” < > “yES” or “NO”
DISPLAY HYSTERESIS VALUES =
If the alarm option is installed, this selects whether the hysteresis values will or
will not be displayed.
“dSPHYS” < > “yES” or “NO”
ENTER HYSTERESIS VALUES =
If “YES” was selected for display hysteresis values, this selects whether
hysteresis values may be modified from the front panel. If “NO” was selected for
display hysteresis values, then this step will default to “NO” and will not be
displayed for selection.
“ENtHYS” < > “yES” or “NO”
= Note: This sequence may be locked-out due to other programmed sequences.
RESET LATCHED ALARMS
If the alarm option is installed and if either alarm is programmed to latch, this
will select if a latched alarm(s) can be reset from the front panel.
“rSt AL” < > “yES” or “NO”
DISPLAY PEAK/VALLEY MEMORY BUFFER
If the totalizer/linearizer option is installed, this selects whether peak and
valley buffers will be displayed.
“dSPbUF” < > “yES” or “NO”
RESET PEAK/VALLEY MEMORY BUFFER =
If “YES” was selected for the previous step, this selects whether the peak and
valley buffers may be reset from the front panel. If “NO” was selected, then this
step defaults to “NO” and will not be displayed for selection.
“rStbUF” < > “yES” or “NO”
SELECT DISPLAY *
If the totalizer/linearizer option is installed, this selects whether the display can be
switched from input display to total display and from total display to input display.
Note: When “NO” is selected, whatever display (Input or total) is shown, will be
the only display accessible.
“SELdSP” < > “yES” or “NO”
RESET TOTAL *
If the totalizer/linearizer option is installed, this selects whether the total can
be reset from the front panel.
“rSttOt” < > “yES” or “NO”
*Note: This function operates independent of the state of the “PGM. DIS.” Pin.
-10-

red lion IMP Specifications

General

Brand	red lion
Model	IMP
Category	Measuring Instruments
Language	English