4. Remove the air outlet.
5. Put grease on the O-ring on the air outlet before you
install the air outlet.
6. Install in the opposite sequence.
7.14.3 To assemble the tube and handle on the
product EBZ8560RH
1. Attach the flexible hose (A) to the pipe angle and the
control pipe (B) with the clamps (C), (D).
Note: Lubricate the control pipe and the flexible hose
to make them more easy to assemble.
2. Attach the handle (E) to the control pipe and put the
knob through the handle.
3. Tighten the knob.
4. Attach the cable to the flexible hose with the cable
clamp.
5. Attach the intermediate pipe to the control pipe. If it
is a tight fit, lubricate with grease in the area shown.
6. Attach the blower nozzle to the intermediate pipe.
38 - Repair instructions 1662 - 003 - 04.11.2021
To Next Page
Loading...
