● The blanking rack that controls the rotating material receiving frame to control the plate ribs
and straight bars
● This button is to select the potentiometer to adjust the speed. When it is switched to ,
the speed can be manually input.
● The button is used when debugging the whole machine. When it is touched, the
whole machine can simulate the stirrup feeding operation. It must be in the valid state of the
encoder during normal operation.
● The button is convenient for the customer to restore the factory parameter setting when the
parameter setting error cannot be used normally, please use it with caution!
● It is the waiting time for the second feeding after each hoop
bending action is completed. The larger the value, the longer the waiting time, the lower the efficiency.
Conversely, the smaller the value, the shorter the waiting time, and the higher the efficiency. But it cannot be
zero! It is advisable not to block the steel bar at the blade edge!
To Next Page
Loading...