● Used to set the bending start point.
If the initial value of the tool setting position in positive
traction along the bend is 30, if the bending 90 degree
difference is 10 degrees compensation, then change 30
to 20.
●Schematic diagram of bending coordinates:
Note: The arrow represents the bending direction, positive bend is a positive number, and reverse
bend is a negative number.
● Display the current coordinates of the bending wheel, used in
conjunction with the starting point of the bending.
● Control the parameters of bending and stretching speed, the smaller the
value, the higher the efficiency.
● Control the speed parameter of the loopback expansion and contraction.
The smaller the value, the higher the efficiency.
● Control the continuous extension time of the material rack, adding or
subtracting according to the actual situation.
● Parameters that control the size of the closed loop. Add or subtract
according to the actual situation. When the actual length is too short, increase the value. The modified
formula is: new parameter=original parameter×actual length÷set length.
●Parameters of receiving rack
Receiving time
Current number
Set the number
Current
OperationManualReflexFastFormGX616CNCRebarStirrupBendingMachine
To Next Page
Loading...