Vacuum spray degassing — 06.07.2016 - Rev. B English —
Filling the device with water
Use the system to fill water into the device.
. Open the "CD" 3-ways motor ball valve to the system.
. Start turning the "PU" vacuum pump at the fan wheel using
a screw driver.
– Injuries caused by pump start-up. Hand
injury due to a pump start. Switch the pump to a zero-volts
state before turning the pump at the fan wheel with a
screwdriver.
– Water flows in and air escapes from the vacuum pump
via the "DV" degassing valve.
To Next Page
Loading...