Reflex Servitec 30 User Manual

Annex
54
— English Vacuum spray degassing — 06.07.2016 - Rev. B
12.2
Conformity and standards
Declaration of conformity for electrical installations in the pressure maintaining, makeup or degassing systems
1. We hereby confirm that the products meets the essential protection requirements as established in the Council Directive to
approximate the laws of the Member States relating to electromagnetic compatibility (2014/30/EU).
The following Standards have been applied to assess the products: DIN EN 61326 – 1:2013-07
2. We hereby confirm that the control cabinets meet the essential requirements of the Low-voltage Directive (2014/35/EU).
The following Standards have been applied to assess the products: DIN EN 61010 – 1:2011-07; BGV A2
Declaration of conformity for a pressure device (tank or assembly)
Applied assessment of conformity procedure according to the Pressure
Equipment Directive 2014/68/EU of the European Parliament and the Council
of 15 May 2014
Design, manufacture, and testing of pressure
equipment
Vacuum spray tube and degassing system: Servitec
For universal application in heating, solar and cooling water systems
Type According to tank nameplate
Serial No. According to tank nameplate
Year of manufacturing According to tank nameplate
min. / max. permissible pressure (PS) According to tank nameplate
Test pressure (PT) According to tank nameplate
Min. / max. permissible temperature (TS) According to tank nameplate
Charging material Water
Standards and set of rules Pressure Equipment Directive AD 2000 according to tank nameplate
Pressure equipment
Tank / vacuum spray tube
Article 4 Para. (1) a) i) 2. dash (Annex II, diagram 2) with
–
Accessories
, Article 4 Para. (1) d): Spray tube, degassing valve, vacuum gauge,
pressure connection with nozzle, level switch, feed and drain cock, connection
hose, suction connection
Assembly
Article 4 Para. 2 clause b comprising:
•
Tank / vacuum spray tube
Article 4 Para. (1) a) i) 2. dash (Annex II, diagram 2)
with
Accessories
, Article 4 Para. (1) d): Spray tube, degassing valve, vacuum
gauge, pressure connection with nozzle, level switch, feed and drain cock,
connection hose, suction connection
–
Accessories
, Article 4 Para. (1) d): Controller with control cabinet and operating
panel, check valve, pressure transducer, 1”ball valve, ½“ ball valve, ½“ ball
valve with dirt trap, pump, 3-ways motor ball valve, 2-ways motor ball valve,
pump drain screw, pump vent screw
Fluid group 2
Conformity assessment to module B+D Servitec
Labelling according to Directive 2014/68/EU CE 0045
Certificate No. of the design type examination See Annex 2
Certificate No., QA system (Module D) 07 202 1403 Z 0780/15/D/1045
Notified body for the assessment of the QA
system
TÜV Nord Systems GmbH & Co. KG
Große Bahnstraße 31, 22525 Hamburg, Germany
Register No. of the notified body 0045
Manufacturer The manufacturer declares that the pressure equipment (the tank / the assembly)
complies with the requirements of Directive 2014/68/EU.
Reflex Winkelmann GmbH
Gersteinstraße 19
59227 Ahlen - Germany
Telephone: +49 2382 7069 -0
Fax: +49 2382 7069 -9588
E-mail: info@reflex.de
Norbert Hülsmann Volker Mauel
Members of the Board of Directors

Reflex Servitec 30 Specifications

General

Brand	Reflex
Model	Servitec 30
Category	Paint Sprayer
Language	English