REFUSOL 40K - Protection against Contact with Hot Parts; Protection During Handling and Assembly

REFU Elektronik GmbH REFUsol 40K / 46K-MV 11
2.6 Protection against Contact with Hot Parts
CAUTION
Danger of burns caused by hot surfaces on housings
At an ambient temperature of 45 °C, the upper part of the housing as well as the
refrigeration unit can reach a surface temperature of more than 75 °C.
 Do not touch the housing surface near to heat sources.
 Allow the device to cool down for 15 minutes before touc
hing the surface of
the device.
Pos: 17 /Inverter M anuals/Sic herheitshinweise/Sc hutz be i Handhabun g und Montag e/WR @ 1\mo d_14047418 79396_641.docx @ 6774 @ 2 @ 1
2.7 Protection during Handling and Assembly
WARNING
Danger of injury during improper handling caused by crushing, shearing,
cutting, striking, and lifting
 The weight of the inverter is 75.6 kg!
 Follow the general setup and safety regulations for handling and assembly.
 Use suitable assembly and transportation equipment.
 Avoid trap and crush injuries by taking suitable precautions.
 Only use suitable tools. Use special tools where this is prescribed.
 Use lifting equipment and tools in a technically correct manner.

If necessary, use suitable protective equipment (for example, goggles, safety
footwear, protective gloves).
 Do not stand under hanging loads.
 Remove any liquids onto the floor immediately to avoid the danger of slipping.