REFUSOL 40K - Monitoring with Refulog; Refuset - PC Configuration Tool

REFU Elektronik GmbH REFUsol 40K / 46K-MV 43
6.3 Monitoring with REFUlog
TheREFUsol 40K / 46K-MV inverter can be connected to the monitoring portal REFUlog using direct Ethernet
connection to the internet, or via RS485 and the REFUcontrol data-gateway.
Once an internet connection is established, the inverter will automatically start to send data to REFUlog
every 5 minutes. The sending interval can be changed with the configuration tool REFUset.
To view the inverter data, open www.refu-log.com with your browser and login or register as a new user.
You can use the activation code provided on the type label of the inverter to assign one or more inverter to a
PV system.
Pos: 62 /Inverter M anuals/Konf iguration/REF Uset/WR @ 1\m od_14050 76152162_64 1.docx @ 712 5 @ 2 @ 1
6.4 REFUset – PC Configuration Tool
You can upgrade the firmware of the inverters and change country-specific parameters of the inverter with
the PC Software REFUset. You can connect the PC with the inverters via Ethernet or USB using a RS485-USB
converter.
For extended settings, you will receive a personal password on request from the REFU Service.
Functions
• Firmware update
• Export of inverter data
• Feed-in conditions voltage and frequency
• Ramp starting time in the event of a grid error
• Average voltage monitoring
• Phase conductor voltage monitoring
• Frequency-dependent power reduction
• Actual voltage monitoring (rapid disconnection)
• Actual frequency monitoring
• Reactive power (cos φ)