2
Chapter 5
ENGINE BREAKIN: ALL MODELS
All propulsion systems require a pre-determined “break
in” period. During this time the engine should not be
run at a full load condition for extended periods. Vari-
ous engine load and speed conditions assist the internal
engine parts such as bearings, valves and piston rings to
“seat” properly which will help ensure a longer engine
life. See operator’s manual for further information.
During the “break in” period it is necessary to check
the engine oil more frequently since it is normal that
the engine will use more oil. If engine oil is required be
sure to check the engine manual for proper grade and
viscosity.
Check the maintenance schedule in your engine own-
er’s manual and contact your Regal dealer to set up the
rst maintenance inspection. Normally the engine oil,
lters, and drive oil inspections and maintenance are
performed during this inspection along with other
items.
Never exceed a 12 month period between oil changes
especially with diesel power since sulfur tends to en-
ter the lubrication system through the fuel combustion
process over a period of time.
OIL CHANGES ENGINE & DRIVE
Be sure to read the owner’s manual regarding engine oil
change recommendations along with stern drive oil. Be
sure to follow the engine manufacturer’s recommended
oil type and viscosity. e engine oil change is an im-
portant factor in obtaining engine longevity since im-
purities enter the crankcase through the combustion
process and build up in the engine oil.
Be sure to check the drive oil on a periodic basis and
change it using the recommended type per the engine
owner’s manual.
To Next Page
Loading...
Need help?
General
