2
Chapter 10
BOAT
1. Check hull bottom for any berglass damage. Repair
as n
eeded.
2. Apply a coat of wax to hull and deck surfaces.
3. Pour a pint of 50/50 antifreeze into bilge pump.
4. Remove batteries. Trickle charge over extended
periods. Do not set batteries on cement. Use wood blocks.
5. Remove all loose gear from boat such as life jackets,
etc. Inspect and store in cool, dry environment.
6. Remove drain plug. Clean drain plug hole of debris
as needed. Enclose drain plug in plastic bag and tie to
steering wheel.
7. Drain the waste system per instructions in this chapter.
Make sure bow is higher than stern to permit proper
drainage.
8. Clean all upholstery and store to permit venting.
9. Conduct a visual inspection to ensure boat is balanced
properly. Bow should sit slightly up especially if outside.
10. Cover boat with tarp. Tie down for wind protection
if outside. Prop tarp up as needed to provide proper
ventilation. Be sure not to cover up the fuel vents.
11. Drain the fresh water system per instructions in this
chapter. (Ensure that the system has been disenfected)
12. Send in appropriate equipment for calibration such as
the automatic re extinguisher canister or CO
detectors.
13. Never use blocking to support the hull bottom as
structural hull damage may occur to the vessel which is
not covered under the warranty.
A. Run engine in water or with ushette attachment at
idle. Pour a fuel stabilizer/conditioner in the fuel tank.
Allow time for it to circulate through the fuel system. Top
o fuel tanks to help prevent condensation.
B. Change all engine uids as referenced in the engine
manufacturer’s owners manual.
C. Drain cooling and exhaust system per engine
manufacturer’s instructions or have a marine professional
“pickle” the engine with antifreeze and rust preventative.
D. Spray all exterior parts with a rust preventative.
e propulsion systems on your boat are complex in
scope. In colder climates, it is recommended that your
Regal dealer winterize your boat’s engine. Regal dealers
have undergone extensive factory training covering the
Regal product line. Also, the dealer is equipped with
the parts and tools to perform a care free winterization
procedures listed below:
DECOMMISSIONING CHECKLIST
EN
GINE- S
TERN DRIVE/OUTBOARD
To Next Page
Loading...
Need help?
General
