16
Chapter 7
Your boat is equipped with a drain plug centrally
located on the transom below deck level. Make sure
it is installed tightly before launching. Tighten with a
small amount of machine torque but do not overtighten
it as the thread material is nylon and can be stripped.
Do not use your ngers alone to tighten it. A er your
outing, while the boat is angled on the ramp, remove the
drain plug to eliminate any bilge water accumulation.
If the water stream is diminished, check for foreign
objects stuck in the drain hole. Pull the drain plug if
dry storing the boat for extended periods, especially in
colder climates.
Refer to the vessel operation chapter for pre-departure
use. Refer to the storage and winterization chapter for
storage information. Review the trailering section for
pre-launch and post-trip instructions.
DRAIN PLUG
To Next Page
Loading...
Need help?
General
