2
Chapter 7
BILGE PUMP/FLOAT SWITCH
Your Regal boat features a bilge pump and oat switch
loc
ated in the sump (bilge). ey are operated through
a helm switch.
In the “o ” position the switch is connected into the
automatic oat switch. In this “auto” position if the boat
takes on water, the bilge pump will activate and pump
excess water overboard. e switch will light up when
activated.
Periodically check the grates for debris and spray the
units down with water. Make sure a steady stream of
water exits the through hull tting indicating the entire
output hose system from the bilge pump itself is debris
free.
Monitor your helm bilge pump switch light periodically
during your cruise. If a light is on that means that the
bilge pump circuit is energied. Stop the vessel and nd
the cause of the problem.
Automatic Float Switch
Grates
Bilge Pump
Output
Hose
To Next Page
Loading...
Need help?
General
