33
Engine & Controls
AFTER FUELING
1. Close all fuel ll openings tightly until the two red
points line up on the fuel ll cap/casting. is is the
proper locked/sealed position.
2. Open all hatches as needed.
3. Sni in the lower bilge and oor storage locker (shown
below) for gas fumes. If fumes are detected continue to
ventilate until the odor is gone. Look for any traces of
fuel droplets or spillage. Do not start the engine, smoke
or run any electrical components until the fumes can no
longer be detected.
FUEL FILL CLOSED AND POINTS LINED UP
4. Locate the fuel line primer bulb. Hold it at an upward
angle and pump it until rm. Periodically check the bulb
for loose connections especially at the fuel tank and at the
engine end. Also, check for signs of cracking on the bulb
rubber surface which can develop with humidity and age.
To Next Page
Loading...
Need help?
General
