24
Chapter 4
Using Fresh Water (Potable) System
1. Verify that the dockside water is pure and safe to use.
2. Fill the fresh water tank using the deck ll labeled water
until water is seen at the water internal deck ll vent.
3. At the helm switch panel activate the fresh water system
breaker. is will energize the water pressure pump to
send fresh water from the potable water tank through the
cold water lines terminating at the various faucets and
related components.
4. Open a faucet. Water pressure should be present.
Opening the faucet for a few seconds will purge any air in
the system especially in cases where the fresh water tank
has run out of water. When water is running at a faucet
it is not unusual to hear the water pump activate as it is
trying to build up the pressure required in the system.
Soon a er the faucet is turned o the fresh water pump
sound will end indicating the fresh water system is now
up to speci ed system pressure.
Note: If the fresh water pressure pump continues to run
long a er the faucets are deactivated check for fresh water
system leaks.
Note: Do not run pressure water pump with system dry
as water pump component damage will occur.
To Next Page
Loading...
Need help?
General
