Equipment Operation
6-87
The Power Tower features an actuator
control box. This component is
located in the sump (bilge). The unit
provides overcurrent protection
through a set of breakers on the face
of the actuator box. Facing the box
the left reset breaker protects the port
power tower lift actuator. The center
reset breaker protects the starboard
power tower lift actuator.
The far right breaker protects the entire circuit wiring. If the Power
Tower fails to raise check the box for an “open” breaker. Always fi nd
the cause of an open breaker situation before resetting the device.
To Next Page
Loading...
