49
Systems
POSSIBLE PROBLEMS/SOLUTIONS
1. After the dockside cord is hooked up to
the boat and the marina dock power cen-
ter and the AC ship’s panel main breaker
for shorepower 1 or 2 is activated no volt-
age is shown on the main panel AC volt
meter.
Check the breaker on the marina dock power center to
ensure it is activated.
Check the ELCI main breaker/voltage sensing device.
The “power” icon should show green. If a leakage fault
exists a “red” icon will light indicating the breaker is
“tripped”. Use the test button to reset the breaker after
the condition has been rectifi ed.
Check the shore power cord for corrosion, faulty wiring
usually at the plugs or broken twist connectors.
Notify marina personnel to verify power at the dock dis-
tribution center.
To Next Page
Loading...
