Regin RCF Series User Manual

RCF manual Chapter 14 Display handling 39
Number of
parameter
Description
Factory
setting (FS)
65 Setting, active buttons
RCF:
0 = No active buttons
1 = Only On/Off button active
2 = Only Up/Down buttons active
3 = On/Off and Up/Down buttons active
4 = Only fan button active
5 = On/Off and fan button active
6 = Up/Down and fan button active
7 = All buttons active
RCFM:
0 = No active buttons
1 = Only On/Off button active
2 = Only Up/Down buttons active
3 = On/Off and Up/Down buttons active
4 = Only M button active
5 = Fan and M buttons active
6 = Up/Down and M buttons active
7 = All buttons active
7
66 Function to prevent users from manually setting the fan speed if the fan
should not run due to cooling/heating output, as specified in parameter
25.
0 = Not active
1 = Active
0
67 The EC fan will start when the output exceeds the set value.
(only RCF-230CTD-EC)
10
68 The maximum speed of the EC fan (only RCF-230CTD-EC) 100
69 Fan kickstart. The fan will run 100 % when starting up for the set time,
0...10 seconds.
0
70 Supply air max limitation for cascade control and heating control 35°C
71
Supply air min limitation for cascade control and heating control
24°C
72
Supply air max limitation for cascade control and cooling control
24°C
73
Supply air min limitation for cascade control and cooling control
12°C
74 Cascade factor between room controller and supply air controller 3°C
75
Frost protection temperature for supply air when supply air temperature
limitation is active
8°C
76 Activate supply air temperature limitation for:
0 = Heating control
1 = Cooling control
2 = Both heating and cooling control
1
*NO = Normally Open, NC = Normally Closed

Regin RCF Series Specifications

General

Brand	Regin
Model	RCF Series
Category	Controller
Language	English