ReliOn Micro - Page 31

31
Step 3: Obtain a blood drop
(see pages 27–28). Apply
blood to the end of the test
strip. Capillary action will pull
the blood into the test strip.
The meter will beep when it
detects that blood has been
applied. The meter will begin
to count down. Do not add
blood on top of the test strip,
as you may receive an inaccurate result.
Not Filled
Filled
Not Filled
Filled
Important
•Ensurethatenoughbloodisappliedtollthecheck
window and it turns red
•Whenthecheckwindowislledwithbloodanda
beep sounds, remove the tip of the test strip from
yournger
• If there is not enough blood, ‘E-7’ or ‘Lo’ will
be displayed