Renault K4M - Page 35

10A-29
ENGINE AND CYLINDER BLOCK ASSEMBLY
Sump: Removal - Refitting
K4M
10A
a Fit the relay bearing bolt (1) without tightening it.
a Tighten to torque:
-the bolts 2 and 3 of the relay bearing (44 N.m),
-the bolt 1 of the relay bearing (44 N.m),
-the bolt 4 of the relay bearing flange (21 N.m).
a Refit the dipstick guide.
a Torque tighten the dipstick guide bolt on the lif-
ting eye (10 N.m).
a Refit the dipstick guide.
a Torque tighten the dipstick guide bolts on the in-
jector holder shim (10 N.m).
a Fill up the engine oil (see 10A, Engine and cylinder
block assembly, Engine oil: Draining - Refilling,
page 10A-40) .
a Refit the engine undertray.
135708
K4M, and 848
K4M, and 858 or 866