10A-43
ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine oil: Draining - Refilling
F4R
10A
a Place the oil recovery container under the engine.
a Remove:
-the drain plug (3) from the engine oil sump using
the (Mot. 1018),
-the sump drain plug seal.
a Let the engine oil flow out.
a Refit:
-a new seal (4) on the sump drain plug,
-the drain plug on the sump.
a Torque tighten the drain plug (20 N.m).
a Clean the traces of oil around the drain plug so that
any possible leaks can be detected.
a Remove the oil recovery container.
IV - FILLING
a Position the vehicle back on the ground.
a Fill the engine with oil, observing the recommended
amount.
a Wait for at least 10 minutes.
a Check the oil level using the dipstick.
a Adjust the engine oil level if necessary.
a Refit:
- the engine oil filler cap,
- the dipstick,
- the engine cover,
- the engine undertray.
123178
113765
To Next Page
Loading...
