If a minimum pressure of 1.8 bar is
not reached after 15 minutes, repair
is not possible; do not drive the ve-
hicle but contact an approved dealer.
TYRE INFLATION KIT (2/3)
With the engine running and the
parking brake applied,
– connect the adapter 8 to the acces-
sories socket on the dashboard of
the vehicle;
– unscrew the valve cap on the wheel
concerned and screw the inflation
adapter 6 onto the valve;
– press switch 3 to inflate the tyre to
the recommended pressure (check
the label affixed to the edge of the
driver’s door);
– after a maximum of 5 minutes, stop
inflating and read the pressure (on
pressure gauge 5); To adjust the
pressure if necessary: continue in-
flating to increase the pressure or
turn button 7 to decrease it.
Note: while the bottle is emptying
(approximately 30 seconds), pres-
sure gauge 5 will briefly indicate a
pressure of 6 bar, then the pressure
will drop.
Depending on the vehicle, in the event
of a puncture, use the kit located under
the luggage compartment carpet: open
the kit, remove caps 1 and 4 (it is es-
sential not to remove the cap from the
bottle) and screw bottle 2 to its base 4.
Before using this kit, park
the vehicle at a sufficient
distance from traffic, switch
on the hazard warning
lights, apply the handbrake, ask all
passengers to leave the vehicle and
keep them away from traffic.
1
3
4
5
6
7
8
2
To Next Page
Loading...
