headrest................................................(up to the end of the DU)
adjusting your driving position ..............(up to the end of the DU)
REAR HEADRESTS
Positions for use
Press tab A of lock 1 and raise the
headrest to its maximum height to use
it in the high position. Lower it until it
locks to use it in the bottom position.
Storage position
Press catch 2 and lower the headrest
completely.
When the headrest is set at the
lowest position (position B) this is
for storage only: It should not be in
this position when a seat is occupied.
To remove the headrest
Press tab A on catches 1 and 2 then
take out the headrest.
To refit the headrest
Insert the rods into the holes, press the
tabs on both rods and lower the head-
rest.
The headrest is a safety
component, check that it is
fitted and in the correct po-
sition.
1
A
2
B
To Next Page
Loading...
Need help?
General
