Renault Modus - Triptic Rear Bench Seat

rear bench seat......................................................(current page)
rear seats
functions ..........................................................(current page)
3.35
ENG_UD20670_2
banquette arrière triptic (X77 ph2 - Renault)ENG_NU_815-9_X77_Renault_3
Triptic rear seat
TRIPTIC REAR BENCH SEAT
This is a sliding bench seat which, in
addition to the settings described in the
previous pages, can be configured to
two or three seats.
Before moving it, ensure that nobody is
occupying the seat or preventing it from
being moved.
Changing to the two-seater
configuration
– lift centre section 1 of the bench
seat;
– lift handle 2 and push the seat base
towards the centre until it locks in
place (the second section of the seat
is recentred at the same time).
Make sure that the seat base locks into
position correctly.
You can then move the bench seat for-
wards or backwards (four possible po-
sitions).
Changing to the three-seater
configuration
– move the bench seat fully forwards,
– lift handle 2 and pull the seat base
until the seat locks in place (ensure
that the seat base is locked correctly
in position);
– lower centre section 1 of the seat.
You can then move the bench seat
backwards a notch (two possible posi-
tions).
Location A is not a storage com-
partment.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
For safety reasons, it is not permit-
ted to sit on the centre seat position
when section 1 is raised.
2
1
2
1
A
1