SLIDING REAR BENCH SEAT (3/3)
To reposition the seat
– Lower the bench seat until it locks in
position;
– fold the seatbacks up again;
– make sure that the seat base and
seatbacks lock into position cor-
rectly.
2
6
7
When the bench seat has
been returned to the posi-
tion for use, check that it is
completely locked into its
anchoring points and that no ob-
jects can accidentally unlock the
controls 7.
To fold down the bench seat
Triptic rear bench seat
This should be in the 3-seater position
(refer to the next page).
Any sliding rear bench seat Bench
seat pushed fully forward with the
headrests in the low position:
– fold down the seatbacks;
– lift controls 7 located on each side of
the bench seat;
– lift the seat base with handle 2;
– take out the strap from storage com-
partment 6;
– attach it to one of the front headrest
rods and pull it taut.
The seat belts are not at-
tached to the floor. For your
safety, when moving the
rear bench seat, check that
the sequence of hooks 9 is clean
(e.g. gravel, cloth, toys, etc.).
It is essential to check that the seat
base hook 8 locks correctly onto the
sequence 9.
Check that the rear seat belts are
positioned and operating correctly
each time the rear bench seat is
moved.
8 9
To Next Page
Loading...
