CHILD SAFETY: fitting a child seat (2/6)
Child seat attached using the ISOFIX
fitting
ü = seat which allows an ISOFIX
child seat to be fitted.
± = the rear seats are fitted with
an anchorage point which allows a
forward-facing ISOFIX child seat
with universal approval to be fitted.
This is located on the roof rear
cross member under a cover.
The size of the ISOFIX child seat is in-
dicated by a letter:
– A, B and B1: for forward-facing seats
in group 1 (9 to 18 kg);
– C: rear-facing seats in group 1 (9 to
18 kg);
– D and E: shell seat or rear-facing
seats in group 0 or 0+ (less than
13 kg);
– F and G: cots in group 0 (less than
10 kg).
Child seat attached using the belt
U = seat which allows a seat with “uni-
versal” approval to be attached
with a belt;
UD = seat which only allows a rear-
facing seat with “universal” ap-
proval to be fitted;
L = seat which allows certain booster
cushions to be fitted. Consult the
booklet available from an ap-
proved Dealer.
Using a child safety system which is not approved for this vehicle will not
correctly protect the baby or child. They risk serious or even fatal injury.
Installation diagram
(sliding bench seats)
³ = check the status of the front
air bag before fitting a child seat
or allowing a passenger to use the
seat.
RISK OF DEATH OR
SERIOUS INJURY: before
fitting a rear-facing child
seat in the front passen-
ger seat, check that the air bag has
been deactivated (refer to the infor-
mation on “Deactivating the front
passenger air bags” at the end of
the paragraph).
To Next Page
Loading...
Need help?
General
